For general information about development setup for Android devices, see the Android documentation.

There are many help resources on the internet that can help you solve Android device detection issues, such as the answers to the ADB No Device Found question in StackOverflow.

If your Android device is not correctly detected by RAD Studio or the system Device Manager, follow the steps above to verify that USB debugging is enabled.

If you accidentally click Cancel, disconnect your device from your PC and connect it back to make the dialog show up again on your device. If you are running Android 4.2.2 or later, you may see the following dialog when you connect your device to your PC running RAD Studio:Ĭlick OK to allow USB debugging on your PC. For more information, see the Amazon documentation. Select Settings > Security and set Enable ADB to On. It also allows you to safely disconnect your phone from your PC.

Go to Settings > Storage > Menu > USB computer connection, and select Camera (PTP).įor more information, see Unlocking Jelly Bean and Higher Devices Tap Charge phone to use only the charging function and not the USB function.

Drag down the status bar, tap Connected as under Notifications, and select Camera (PTP).

Depending on your Android version, you must do either of the following:

If you are running Windows 8, you must configure the USB connection as Camera (PTP).

Tip: You might also want to enable the Stay awake option, to prevent your Android device from sleeping while plugged into the USB port.

Tap the Build number seven times to make Settings > Developer options available.

On the device, go to Settings > About.

I am tetherered to my modem via ethernet, i use the asus rx86u on 5ghz access point mode and the quest is the only device connected to it. The steps to enable USB debugging depend on the version of Android running on the target device, as indicated in the following table:Įnable the USB Debugging option under Settings > Developer options.įor Android 4.2 and newer, Developer options is hidden by default use the following steps: So my airlink works just fine, but occasionally i get randomly disconnected for a few seconds.

Asus pc link disconnects